The Mini V2 comes pre-configured out of the box. If you do have a little more to spend, consider one with a slightly larger build area. Note, this does mean some models may be a bit large to print without breaking them into pieces, but printers with a 6’ x 6’ build area are more than I was prepared to spend and I was ok with compromise on this one point. The build area is a 120 mm cube, or just shy of 5 inches along the X, Y and Z axis. It was a bit daunting, because there seemed to be a lot to learn just to get started, but I found an excellent entry-level printer, the Monoprice Select Mini V2, for around $250 (including the first spool of filament).įirst, I must say the MP Mini is an amazing entry level 3D printer. You may have read in an earlier post that I funneled some funds that might have been spent on other terrain into a new 3D printer. I modified some arched corners for my dungeon. Mixing existing OpenLOCK and OpenForge tiles,
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |